beautifullop.blogg.se - december 2022

Slide 7 of 6*12mm bolts into the channel on the top of the tubing on the sides on the rack.Step 6: Fasten bottom ladder section using bolts(5). Step 5: Mount bottom section of ladder by removing existing body bolts. Step 2: Drill 2 6mm holes in body cross bar.

Step 1: Mont top section of ladder on gutter.

Finally do a pre-flight inspection to ensure nothing has been omitted, or not fully tightened.

Once clamps are in position and tightened, tighten grubscrews.

Avoid overtightening and thereby distorting vehicle gutter.

Place gutter clamps into position and tighten down.

Hand tighten grubscrews into position(5).

Align back of the rack flush with rear of vehicle.

Racks weigh on average 50kg, seek assistance when lifting onto vehicle to avoid injury(minimum 4 people ).

Align all legs and bolt together,(2) and (3) including washers, top and bottom.

Slot 50*25 extrusions into position on legs(3).

Place all 50*25 tubings (2) cross members in position on legs, and attach self adhesive rubber strips.Attach rubbers to gutter support rails.